Coleman MACH Single Stage Cool Only Digital Wall Thermostat

It’s about that time isn’t it? Time to upgrade your outdated analog thermostat to a brand new digitized thermostat! 

Or maybe it’s been several years and your existing digital thermostat has been through the ringer and you’re just ready for a new one. Whatever your reasoning may be, we at Dyer’s are happy to provide you with the latest and greatest!

This thermostat controls ‘Cool Only’ Coleman MACH air conditioners (not compatible with heat pumps, heat strips, or furnaces). Check out some of our “Related Products” down below to find a replacement thermostat that will work with what you are needing.

The thermostat wiring is factory installed by the OEM. It is intended for use with a 12VDC control circuit that does not exceed 1 amp. It is equipped with a 2 amp fuse located on the base of the thermostat.

The fuse is designed to open if the circuit is wired wrong or if there is a short in the system. Before replacing the fuse, the cause of the failure must be located & corrected by a certified technician.

**Locate the thermostat on an inside wall about 5 feet above the floor. Pick a dry area where air circulation is good. DO NOT INSTALL thermostat in direct sunlight, near heat producing appliances or a furnace or air conditioner supply register.**

Per manufacturer policy and guidelines, for safety and liability reasons, a registered technician is required to handle the installation and/or repairs of this product.